Author Topic: Saving a cheat engine modification to the exe, or using instructions in notepad  (Read 1508 times)

Tsunamix

  • *
  • Posts: 805
  • I prefer to work with someone than against them.
    • View Profile
    • The home of Tsunamods
When i write a hex notepad for an IRO file. Sure i can just write xxxxxxxx = xxxxxxx and leave it.
BUT how do i tell it to change said address to be a call or an ecx or blah blah 

Or how do i go about saving my changes inside the actual exe so i can release it instead?
« Last Edit: 2017-12-05 00:29:41 by Tsunamix »

Tsunamix

  • *
  • Posts: 805
  • I prefer to work with someone than against them.
    • View Profile
    • The home of Tsunamods
Changed topic name with extra stuff matching this threads topic

Grimmy

  • *
  • Posts: 496
  • Join in my tarnished light.
    • View Profile
    • GrimmyGames
« Last Edit: 2017-12-07 23:47:46 by Grimmy »

Tsunamix

  • *
  • Posts: 805
  • I prefer to work with someone than against them.
    • View Profile
    • The home of Tsunamods
Yeah i have no idea if edits to the op makes it appear in your "Unread posts" or not so i didnt really have much of a choice

Maki

  • 0xBAADF00D
  • *
  • Posts: 602
  • 0xCCCCCCCC
    • View Profile
You're talking about assembler. After doing changes in the EXE just note the bytes and relative offset and then HEX modify the file. If you need to edit source assembler file by inputting mnemonics then use IDA or OllyDbg.