I noticed that in STAGE10, the Shinra Logo on the floor IS NOT shown correctly , upper half of it was CUT and replaced by lower half attatched to its lower half.
I tried to correct this. and here's the result.
BEFORE;
AFTER;
All I did are;
1 Open oqaa with Kimera.
2 Make oqam half leavinng -z side along with x axis.
3 save it as oqak.
4 make mirror image of oqam which is already cut half.
5 save it as oqal.
6 make texture oqac normal with Shinra Logo using Photoshop or some other image making software,
5 save it as oqac with Image2TEX.
6 copy "mirrored" upper half of Shinra Logo to the same position of the picture STEP6.
7 save it as oqah with Image2TEX.
8 Now re-open oqaa with Kimera.
9 Click oqam and add oqak. Remove oqam(we dont need it anymore. Don't worry it will be made again in Kimera).
10 Make sure texture is displayed correctly on oqak.
11. Add oqal(mirrored oqak) to the bone of oqak added in STEP 9.
12. Add texture to oqal and save the model oqaa.
This saving action eliminates the crash problem of Kimera in my case.
13. Re-open oqaa and click oqam (it was united from oqak and oral in step12).
14 Add texture oqah (with mirrored upper half of Sinra Logo).
15. Set Texture ID to 5 in Group 1 Texture Property of oqam with Kimera.
15 All is OK ? you can see the whole Sinra Logo displayed correctly?
16 Save oqaa. Done
Files for dowaload;
http://www.mediafire.com/download/m59obe5n522nfro/battle-STAGE10.rar