Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - reshin

Pages: [1]
1
Bootleg Questions / Re: [Tutorial] Tifa's Bootleg
« on: 2013-07-25 22:36:35 »
What steps should I take with a Windows 7 to fully reinstall FFVII with the steam release, since my APP.log is empty as well?  I had followed the tutorial previously up to the "Run Bootleg" step, which briefly brings up the command prompt in a new window, and then closes after a few seconds, seemingly without doing anything.  Also, I didn't use the steam mover, I did move everything per a tutorial on moving the steam installation.  Any ideas of where I should start?

2
Bootleg Questions / Re: [Tutorial] Tifa's Bootleg
« on: 2013-07-25 05:18:55 »
All right, I found the app.log, and it's totally empty.  Ran a couple of googles, which mentioned the possibility of a UAC problem, but I already set it to the minimum...I'm running Windows 7.

3
Bootleg Questions / Re: [Tutorial] Tifa's Bootleg
« on: 2013-07-23 21:58:55 »
As embarrassing as this is, I don't see an app.log file anywhere in the bootleg folder.  Help?

4
Bootleg Questions / Re: [Tutorial] Tifa's Bootleg
« on: 2013-07-23 01:52:33 »
Well, I went back and deleted the old Bootleg folder.  Redownloaded, didn't extract, but it didn't change my results, unfortunately.  It did seem like my command prompt window was open for a second or two longer.  Doublechecked the locations, which seem to be accurate.  I'm still not getting to the next step.  Any other ideas?

5
Bootleg Questions / Re: [Tutorial] Tifa's Bootleg
« on: 2013-07-22 23:16:10 »
Hello,

I'm running the Steam release on a Windows 7 desktop, and I did move the Steam installation to a non system directory.  Had no problems with that.  I then proceeded to download the mods that were given for the "Minimal" preset setup.  I did download the files.  I also unzipped (which I'm not sure I needed to do), and when I rerun the mod list, I have only green and yellow items on the mod list, so it looks like I'm clear for the next step.  However...when I click on Run Bootleg, the command prompt does appear for roughly 5 seconds.  The window then closes, and nothing else happens.  I'm returned to the Bootleg program. 

Something I'm just now noticing in the instructions that may have been a problem is that I had an internet explorer open as well as some mozilla firefox windows.  Where do I need to go from here?

Pages: [1]